This is yet another project based on LM358. The LM158 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent…
This is a basic electronic kit based on LM358. The LM158 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain…
It’s a simple project to build a stereo preamplifier using electret microphones and the cheap operational amplifier LM358. In the past, we have made few projects comprising LM358, you can check them here. This project uses the dual-channel operational amplifier LM358. Each channel is used to increase the signal of one electret microphone and it…
Description: LM358 is also one of the types of operational amplifier. LM358Â consists of two independent, high-gain, frequency-compensated operational amplifiers designed to operate from a single supply over a wide range of voltages. This module can also be used for testing an LDR, a phototransistor and a photodiode. You just need to replace an LDR with…
This project is a microphone pre-amplifier based on LM358. DESCRIPTION This is easy to construct microphone pre-amplifier project using compact electret condenser microphone. The pre-amplifier is important building block of many audio communication systems. Circuit has been built around Op-Amp LM358. Power supply : 5 to 12 VDC @ 10 mA Output: Gain Approx. 100 On-Board…
The pressure sensor amplifier built using LM358 op-amp and MPXM2051GS pressure sensor from NXP semiconductor.  The circuit provides 4V output for full scale pressure input 0-7.5PSI. One op-amp is used as amplifier and 2nd op-amp is used as comparator to provide an output at set value that can be used as over pressure switch to control…
Current sensor amplifier and over current switch project is based on ACS714-30A current sensor and LM358 Op-amp, ½ of LM358 op-amp used as an amplifier for low voltage  and 2nd 1/2 LM358 op-amp used as comparator which provides over current TTL output, trimmer potentiometer provided to set the over current limit. ACS714 sensor measures the current…
Heat-activated cooling fan controller is a simple project which operates a brushless fan when the temperature in a particular area goes above a set point, when temperature return normal, fan automatically turns off. The project is built using LM358 Op-amp and LM35 temperature Sensor. Project requires 12V DC supply and can drive 12V Fan. This…
This sound sensor with Relay driver shield for Arduino Nano can be used to develop sound-activated ON/OFF switch or other projects that require sound senor. LM358 op-amp is used as the amplifier, 1st op-amp amplifies the microphone signal, and 2nd op-amp works as a half-bridge rectifier that converts AC signal into a DC voltage. This DC voltage is connected…
This is a basic electronic kit for beginners. The kit is based on LM358, an operational amplifier and works as a flame sensor. The schematic of the kit: Check out the images below to get tips for assembling the kit. You can see the images on Flickr also. Other images
There are hundreds of electronics projects published on buildcircuit.com. This time we have selected few projects that should be easier for beginners to start with. Complex and difficult projects just frustrate the beginners. The best thing about the listed projects is that all come with good assembly images and most of the projects can be…
